CNCRouterParts
Search:
What's New: RSS FeedFind us on FacebookYouTube
Shopping Cart:
0 items
PRO CNC

Standard CNC

Benchtop CNC

Electronics

Tooling

Other Products

Plans & Info

Read What Others Are Saying
Displaying 1 to 6 (of 31 reviews) Result Pages:  1  2  3  4  5 ...  [Next >>] 


Linear Carriage with ABEC 7 Bearings   by Michael Sundman Date Added: December 7, 2016
Linear Carriage with ABEC 7 Bearings
These arrived yesterday in pristine condition every bearing block was separated from each other and the hardware kits were each individually packaged with the bearings in their own plastic tube. So wh... view full review

Rating: 5 of 5 Stars! [5 of 5 Stars!]


Extended Linear Carriage with ABEC 7 Bearings   by Michael Sundman Date Added: December 7, 2016
Extended Linear Carriage with ABEC 7 Bearings
These arrived yesterday in pristine condition every bearing block was separated from each other and the hardware kits were each individually packaged with the bearings in their own plastic tube. So wh... view full review

Rating: 5 of 5 Stars! [5 of 5 Stars!]


Extended Linear Carriage with ABEC 7 Bearings   by mike Hewlett Date Added: December 5, 2016
Extended Linear Carriage with ABEC 7 Bearings
Super nice and ridged!!!! For the price I didn't know what to expect, they are made perfect. Takes less than 20 seconds to adjust out the play in them if the cold roll bar you need to buy ever wears... view full review

Rating: 5 of 5 Stars! [5 of 5 Stars!]


4-Axis Digital Plug and Play NEMA 23 System   by Ryan Mandell Date Added: September 18, 2016
4-Axis Digital Plug and Play NEMA 23 System
What a great package! I previously ran my CNC with a Gecko 540 and Meanwell power supply. There was a constant audible hum and motor chirping at start and stop of movement. Now, I can't even tell if i... view full review

Rating: 5 of 5 Stars! [5 of 5 Stars!]


Gantry Interface Plate for 4" Steel   by Sean Saidoo Date Added: June 16, 2016
Gantry Interface Plate for 4" Steel
I apologize, I was wrong!!! You can attach a gantry set, it just needs to favor one side. There are threaded holes for one side gantry riser and the other side shares the holes used to attach the line... view full review

Rating: 5 of 5 Stars! [5 of 5 Stars!]


Gantry Interface Plate for 4" Steel   by Sean Saidoo Date Added: June 16, 2016
Gantry Interface Plate for 4" Steel
I want to start by saying the craftsmanship is top notch on this part. It is very stout and clean looking. However, I was disappointed to find there are not any holes that allow you to attach the CN... view full review

Rating: 4 of 5 Stars! [4 of 5 Stars!]


Displaying 1 to 6 (of 31 reviews) Result Pages:  1  2  3  4  5 ...  [Next >>]